Wildcard SSL Certificates

ETCC FORMS CENTRAL


 

You have selected CONTACT RSGB BEACON MANAGER

Declare a station [25W and under] and request an ETCC Frequency Assignment Certificate.
Use to update the Status or any other changes to a self-declared station 25 Watts and under.
Notify of a Permanent Closedown (by the Keeeper)
Send us a NEWS item for publication
Report a Change of Operational STATUS (Keepers should use the Secure Code Form above)
Apply for a new UK AMATEUR BEACON (includes BEACON Site Changes)
Use you Ofcom Licence Number to apply for a lost Access Code
Keep us up to date with a Review of your station
Apply for a Change of KEEPER (by existing Keeeper)
Get frequency co-ordinated for a new frequency or site

Using autofill? - please check it does not incorrectly populate the form!

Section 1 - The Keeper for

1.1 Your Name:G   *    1.2 Your Callsign:  *
1.3 Licence Mailing Address: 
  
1.4 Town/County:      1.5 Postcode: 
Phone Numbers: 1.6 Principal contact (mobile):   *
1.7 Alternative (landline): 
1.8 E-mail address:  *
1.9 Optional Web address:
 

please omit http://

 
1.10 Ofcom Licence:  * 

(likely be in format similar to 1-8543-123456)


Section 2 - Service

2.1 Requested Callsign:
 
   NOTE: For RF INTERNET REPEATER LINK enter the REPEATER callsign here.

2.2 ETCC Region: 
You will be allocated an ETCC vetting agent depending on the type of application and your location.
You will be contacted by that person once your application has successfully entered our system.

2.3 Type Code:   *
2.4 MODES REQUIRED:

  ANALOGUE VOICE*
 TELEVISION
 PACKET DATA
 BEACON
 (none of above)
 DV DMR
 DV DSTAR
 DV FUSION
 DV P25
 DV NXDN
 M17
 TETRA [Note: Requires a separate simplex frequency, this is NOT a multimode add-on]
OTHER 

2.5 DMR Network:   

(for DMR only)

2.6 DMR COLOUR CODE:  

(Select colour code if using DMR)

2.7 CTCSS:   

(Select CTCSS code for analogue mode if applicable)

2.9 Reason:  *
2.10 Band: 
2.11 Channel:
 

The ETCC will allocate a channel based on the band you have selected above and the availability of channels/spectrum appropriate to your application.

2.12 TX (TV and non std):  MHz 

(If you have a preferred frequency you can enter it here)

2.13 RX (TV and non std):  MHz 

(Note that frequencies will be allocated by the RSGB)

2.14 alt.RX Frequency:  MHz
2.15 Channel Bandwidth:  kHz  

[TX]
(All 2m and 70cm voice repeaters use 12.5kHz except 70cm [RB0-RB15] still on 25kHz)


Section 3 - The Site


3.1 Describe Site:
 
  km  *  3.2  of 3.3 (town)     * 

(within 6km)

  

You can use Grid Reference Finder to check NGR and grid references (separate window)

3.4 NGR:
 
 
  *  or Irish Grid   

(Minimum 3+3 digits, e.g.TQ123987)


For RF INTERNET LINK the NGR and other site details should be for your station, NOT the repeater.


Alternatively, you can enter the location using "what3words" if known.

WGS84:
 
 3.5 Latitude   3.6 Longitude 

Use decimal format, e.g 55.12346,-2.98754 (West of Greenwich is "-")

3.7 Previous site (NGR):   

NGR of current/prev site for SITE CHANGES

3.8 IARU Locator:  
3.9 Site Address:  different (enter below)     same as applicant)

3.10 Site Name/Address: 
  
3.11 Town/County: 
3.12 Site Postcode:  *


Section 4 - Equipment

Transmitter:


(important!)
  4.1 Transmitter type:    

include Make/Model


4.2 Transmitter Antenna [make and model]:  *
4.3 Antenna Gain:  dBd  *  

(Quote dBd NOT dBi -check spec sheet!)


4.4 Height agl:  Metres  * 

(This is the height above GROUND level, NOT sea level!)


4.5 Transmitter Power Output (Watts):  *  Watts
4.6 Losses in System:  dB  *  

(Includes feeder and duplexer losses)


4.7 Direction:   

If not OMNI enter degrees ETN


4.8 Polarisation: Vertical     Horizontal
4.9 Elevation:  degrees  

 If not 0, enter tilt applied



  (Click | Check | Adjust)

Voice Repeaters will not be licensable above 25W (14dBW)
Gateways Maximum ERP limits 2 Metres, 4 Metres, 6 Metres and 10 Metre = 3 dBW,
70cm Gateways 7 dBW, Packet stations Max ERP 7 dBW, APRS Max ERP 3dBW


 

Receiver:

(if applicable)
  4.10 Receiver type:    

(if duplex system)


4.11 Receive Antenna:  different (enter below)     same as TX
RX if different:   4.12 Type:    4.13 Gain:  dBd    4.14 RX Ant.Height agl:  M

Section 5 - Additional Data

5.1 coverage description:
5.2 Support Message:

(may be published)

5.3 Private Message:

(seen by ETCC agents only)


 
 

Section 6 - Data Security [Important Final Bits!!]

** Please note that there are mandatory response boxes in this final section! **

  • 6.1 We recommend that you have 3rd Party insurance liability cover, but it is your responsibility.
  • 6.2 It is YOUR responsibility to ensure compliance with current EMF requirements around the station.
    Click here for further information. [opens in separate page]
  • Data Protection and Privacy
    Please click here to read about our privacy and data protection policies.
  • 6.3 Please indicate your agreement to the collection of information.
    Even if you previously agreed, this must be re-confirmed under current data protection rules.
    In agreeing, you are also stating that you are over the age of 16.
    AGREE      DISAGREE 
      *
  • 6.4 Please indicate your agreement to showing site detail and any associated coverage map. 
     PUBLIC      RESTRICT 
      *
  • NOTE: Choosing site privacy (RESTRICT) in 6.4 above will mean the following:


  1. We will NOT display a detailed coverage prediction map for your station.
  2. Where possible we will truncate or omit your site Grid Reference from lists.
  3. We will not provide links to mapping which show the repeater site.
  4. Your site will not appear in lists used by equipment suppliers for rig programming.
  5. We will try and keep as low a profile for your repeater as practical.

If you have previously agreed to us displaying accurate locations, you may change your mind at any time by contacting us from the ukrepeaters website.


Click here to view the RSGB ETCC Privacy policy document.


PLEASE NOTE THAT IF YOU DO NOT AGREE TO THE COLLECTION OF YOUR DATA WE WILL BE UNABLE TO PROCESS YOUR APPLICATION AND YOU WILL HAVE TO CONTACT OFCOM DIRECTLY.

Your secure access code remains unchanged and is shown below:
 

Finally, check you have answered ALL questions, not forgetting the potential show-stopper if you fail to respond to the important data security questions in Section 6 above!


 
 
Just once only please, and good luck with your application!        G
ukrepeater.net - all about UK amateur radio repeaters
   HomePage    About   RSS  ContactUs    SiteMap    
 free of sponsors – free of ads – no cookies – no registration – yours to enjoy!